Dot1X Initialize Interface - Allied Telesis AT-IX5-28GPX Manual

High availability, high power video surveillance poe switch

Hide thumbs Also See for AT-IX5-28GPX:

Table of Contents

X INITIALIZE INTERFACE

dot1x initialize interface

This command removes authorization for a connected interface with the

specified<interface-list>. The connection will attempt to re-authorize when the

specified port attempts to make use of the network connection.

the reauthorization attempt is not triggered by this command. The attempt is triggered

by the first packet from the interface trying to access the network resources.

dot1x initialize interface <interface-list>

Privileged Exec

To initialize 802.1X port authentication on the interface port1.0.2, use the

To unauthorize switch port1.0.1 and attempt reauthentication on switch

port1.0.1, use the command:

To unauthorize all switch ports for a 24-port device and attempt reauthentication,

use the command:

show dot1x interface

dot1x initialize supplicant

Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch

: Reauthentication could be a long time after the use of this command because

<interface-list> The interfaces or ports to configure. An interface-list can be:

dot1x initialize interface port1.0.2

dot1x initialize interface port1.0.1

dot1x initialize interface port1.0.1-port1.0.24

AlliedWare Plus™ Operating System - Version 5.4.5-0.x

• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),

a static channel group (e.g. sa2) or a dynamic (LACP)

channel group (e.g. po2)

• a continuous range of interfaces, ports, static channel

groups or dynamic (LACP) channel groups separated by a

hyphen; e.g. vlan2-8, or port1.0.1-1.0.6, or sa1-2,

• a comma-separated list of the above; e.g.

port1.0.1,port1.0.2-1.0.4. Do not mix interface

types in a list

The specified interfaces must exist.

C613-50057-01 REV A