Loop-Protection Action - Allied Telesis AT-IX5-28GPX Manual

S C
WITCHING OMMANDS
-
LOOP PROTECTION ACTION

loop-protection action

Overview Use this command to specify the protective action to apply when a network loop
is detected on an interface.
Use the no variant of this command to reset the loop protection actions to the
default action, vlan-disable, on an interface.
NOTE
message will be displayed.
Syntax
loop-protection
action {link-down|log-only|port-disable|vlan-disable|none}
no loop-protection action
Default loop-protection action vlan-disable
Mode Interface Configuration
Usage See the "Loop Protection" section in the
Configuration Guide
information prior to applying this command.
Example To disable an interface (port1.0.4), and bring the link down, when a network
loop is detected, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related loop-protection
Commands
loop-protection timeout
show loop-protection
thrash-limiting
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
: Currently the learn-disable parameter is not supported. If specified, an error
Parameter Description
Block all traffic on a port (or aggregated link) that detected the
link-down
loop, and take down the link.
Details of loop conditions are logged. No action is applied to the
log-only
port (or aggregated link).
Block all traffic on interface for which the loop occurred, but keep
port-disable
the link in the up state.
Block all traffic for the VLAN on which the loop traffic was
vlan-disable
detected. Note that setting this parameter will also enable ingress
filtering. This is the default action.
Applies no protective action.
none
for relevant conceptual, configuration, and overview
configure terminal
interface port1.0.4
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Switching Feature Overview and
loop-protection action link-down
365