Show Power-Inline Interface - Allied Telesis x510-28GTX Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE INTERFACE

show power-inline interface

Overview This command displays a summary of Power over Ethernet (PoE) information for
specified ports. If no ports are specified then PoE information is displayed for all
ports.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show power-inline interface [<port-list>]
Syntax
Mode User Exec and Privileged Exec
Example To display the PoE port-specific information for all PoE ports on the switch, use the
following command:
awplus#
To display the PoE port specific information for the port range1.0.1 to 1.0.4, use the
following command:
awplus#
Output Figure 19-4: Example output from show power-inline interface
awplus#show power-inline interface port1.0.1-port1.0.4
Interface Admin
port1.0.1 Disabled Low
port1.0.2 Enabled
port1.0.3 Enabled
port1.0.4 Disabled Low
Table 3: Parameters in show power-inline interface output
C613-50170-01 Rev B
Parameter Description
<port-list>
Enter the PoE port(s) to display PoE specific information in the show
output.
show power-inline interface
show power-inline interface port1.0.1-port1.0.4
Pri Oper Power Device
Disabled
High Powered 3840 Desk Phone
Crit Powered 6720 AccessPoint 2
Disabled
Parameter Description
Interface The PoE port(s) in the format portx.y.z, where x is the device
number, y is the module number within the device, and z is the
PoE port number within the module.
Admin
The administrative state of PoE on a PoE port, either Enabled or
Disabled.
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Class Max(mW)
0 n/a n/a
1
0 n/a n/a
"Getting Started
Guide.
n/a
5000 [U]
7000 [C]
n/a
745