Reassembly - Toyota T100 1996 Service Manual

EM−48
Protrusion
47.0 mm
Sealant
SST
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)

REASSEMBLY

HINT:
1.
HINT:
When using a new cylinder head, spark plug tubes must be
installed.
(a)
Mark
Z11449
(b)
P14649
(c)
Protrusion
NOTICE:
Avoid pressing a new spark plug tube in too far by measur-
ing the amount of protrusion while pressing.
P14662
2.
(a)
HINT:
Different oil seals are used for the intake and exhaust.
P14651
− CYLINDER HEAD
Thoroughly clean all parts to be assembled.
S
Before installing the parts, apply new engine oil to all slid-
S
ing and rotating surfaces.
Replace all gaskets and oil seals with new ones.
S
INSTALL SPARK PLUG TUBES
Mark the standard position away from the edge, onto the
spark plug tube.
Standard protrusion: 47.0 mm (1.850 in.)
Apply adhesive to the spark plug tube hole of the cylinder
head.
Sealant:
Part No.08833−00070, Adhesive 1324, THREE BOND
1324 or equivalent
Using a press, press in a new spark plug tube until there
is 47.0 mm (1.850 in.) protruding from the camshaft bear-
ing cap installation surface of the cylinder head.
INSTALL VALVES
Using SST, push in a new oil seal.
SST 09236−00101 (09236−15010)
Code mark (Intake side only): "H"
EM07D−02