Toyota T100 1996 Service Manual page 782

Adjusting Bolt
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
28.
29.
(a)
(b)
(c)
30.
31.
P15813
32.
(a)
(b)
(c)
(d)
SST
P15755
33.
(a)
Look Bolt
(b)
P14841
34.
(a)
(b)
35.
36.
P24651
− CYLINDER HEAD
ECT sensor connector
S
Oil pressure sensor connector
S
w/ A/C:
S
A/C compressor connector
INSTALL THROTTLE BODY (See page MF−30)
INSTALL WATER OUTLET
Install a new gasket and water outlet with the 2 bolts.
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)
Connect the ECT sender gauge connector.
Connect the radiator inlet hose.
INSTALL IGNITION COIL.
INSTALL NO.1 AND NO.2 PCV HOSES
INSTALL PS PUMP AND BRACKET
Install the PS pump bracket with the 4 bolts.
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)
Connect the PS pump to the bracket with the 2 bolts.
Torque: 58 N·m (590 kgf·cm, 43 ft·lbf)
Connect the 2 air hoses to the intake chamber.
Using SST, install the PS pump pulley with the nut.
SST 09960−10010 (09962−01000, 09963−01000)
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
INSTALL PS PUMP DRIVE BELT AND IDLER
PULLEY
Install the idler pulley with the 3 bolts.
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)
Install and adjust drive belt (See page CH−2).
INSTALL AIR INTAKE CONNECTOR
Install the air intake connector with the 2 bolts and hose
clamp.
Connect the 2 air hoses.
M/T:
CONNECT ACCELERATOR CABLE TO THROTTLE
BODY
A/T:
CONNECT THROTTLE AND ACCELERATOR CABLES
TO THROTTLE BODY
EM−59