Toyota T100 1996 Service Manual page 794

1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
8.
(a)
(b)
(c)
(d)
P15073
(e)
9.
10.
11.
(a)
(b)
P15072
(c)
(d)
R05270
12.
(a)
(b)
(c)
P15078
− ENGINE UNIT
INSTALL FRONT EXHAUST PIPE
Install 2 new gaskets and the front exhaust pipe assembly
with new 3 nuts.
Torque: 62 N·m (630 kgf·cm, 46 ft·lbf)
Install the support bracket with the 2 bolts.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Connect the clamp and tighten the clamp bolt.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
Connect a new gasket and the front exhaust pipe assem-
bly to the TWC with the 2 bolts and retainer.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Connect the 2 heated oxygen sensor connectors.
CONNECT SPEEDOMETER CABLE
INSTALL PROPELLER SHAFT (See page PR−9)
INSTALL STABILIZER BAR
Place the stabilizer bar in position and install both stabiliz-
er bar bushings and brackets to the frame.
Torque the stabilizer bar mounting bolts.
Torque: 30 N·m (306 kgf·cm, 22 ft·lbf)
Connect the stabilizer bar on both sides to the lower arms
with brackets, cushions and new nuts as shown.
Torque the nuts.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
M/T:
INSTALL SHIFT LEVER ASSEMBLY
Install baffle and shift lever assembly with the 6 bolts.
Install the shift lever boot with the 4 screws.
Install the shift lever knob.
EM−71