Cylinder Block Disassembly - Toyota T100 1996 Service Manual

EM−76
Knock
Sensor
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
SST
P14816
Oil Pressure Switch
SST
P15971
P14771
− CYLINDER BLOCK
DISASSEMBLY
1. M/T:
REMOVE FLYWHEEL
Remove the 10 bolts and flywheel.
2. A/T:
REMOVE DRIVE PLATE
Remove the 10 bolts, front spacer, drive plate and rear spacer.
3. REMOVE REAR END PLATE
Remove the 3 bolts and rear end plate.
4. INSTALL ENGINE TO ENGINE STAND FOR DIS-
ASSEMBLY
5. REMOVE CYLINDER HEAD (See page EM−28)
6. REMOVE TIMING CHAINS, GEARS AND SPROCKET
(See page EM−14)
7. REMOVE FUEL FILTER
Remove the 2 bolts and fuel filter.
8. REMOVE KNOCK SENSOR
Using SST, remove the knock sensor.
SST 09816−30010
9. REMOVE WATER BYPASS PIPE
Remove the bolt and water bypass pipe.
10. REMOVE OIL FILTER AND BRACKET
(a) Remove the oil filter (See page LU−3).
(b) Remove the 2 bolts, nut, oil filter bracket and O−ring.
11. REMOVE OIL FILTER BRACKET UNION
Using 14 mm hexagon wrench, remove the union and O−ring.
12. REMOVE ENGINE COOLANT DRAIN PLUG
13. REMOVE OIL PRESSURE SWITCH
Using SST, remove the oil pressure switch.
SST 09816−30010
14. REMOVE RH ENGINE MOUNTING BRACKET
Remove the 4 bolts and bracket.
15. REMOVE LH ENGINE MOUNTING BRACKET
Remove the 5 bolts and bracket.
16. REMOVE REAR OIL SEAL RETAINER
Remove the 6 bolts and retainer.
EM07L−02