Mpls Ldp Targeted-Hello Holdtime - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

Chapter 13: M Commands

mpls ldp targeted-hello holdtime

mpls ldp targeted-hello holdtime seconds
Syntax
no mpls ldp targeted-hello holdtime
Command introduced in JUNOSe Release 8.1.0.
Release Information
Configures the LDP targeted-hello hold time, the period for which a sending LSR
Description
maintains a record of targeted hello messages from the receiving LSR without receipt
of another targeted hello message from that LSR. Each LSR peer sends the hold time
in its targeted hello messages; peers negotiate to use the minimum of the hold times
proposed by the pair of LSRs.
The hold timer is restarted whenever the LSR receives a targeted hello from the peer
in the targeted hello adjacency. The timer expires if no targeted hello is received
from the peer within the hold time. The LSR deletes the targeted hello adjacency
when the timer expires. If all targeted hello adjacencies are deleted for an LDP session,
then the LSR terminates the LDP session.
This command takes effect immediately. The no version restores the default value,
45 seconds.
seconds Number of seconds, in the range 1–65535
Options
Global Configuration
Mode
1357
mpls ldp targeted-hello holdtime