Task 2: Divert Network Traffic To Another Router; Task 3: Access Privileged Exec Mode; Task 4: Configure Ip On An Interface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Task 2: Divert Network Traffic to Another Router

Task 3: Access Privileged Exec Mode

Task 4: Configure IP on an Interface

120
The password (if one is configured) that enables you to access Privileged Exec mode
on the router
The IP address of the network host
The IP address of the router
The IP address of the next hop to reach the destination network (for example, a
gateway)
The login name and password for the vty line
The procedure for copying the release files to the network host
The system will be unavailable during the installation process.
To access this mode via the CLI:
Issue the enable command.
1.
host1>enable
Type the password if the system prompts you.
2.
Typically, you configure IP on the Fast Ethernet interface of the SRP module. To configure
IP on an interface:
Determine the slot number of the module.
1.
host1#show version
Determine the port number of the module.
2.
Determine whether the interface already has an IP address.
3.
On ERX7xx models, ERX14xx models, and the ERX310 router:
host1#show ip interface fastEthernet 6/0
On the E120 and E320 routers:
host1# show ip interface fastEthernet 6/0/0
NOTE: If an IP interface is not configured, an Invalid interface message
appears.
If the interface already has an IP address, go to Step 5. Otherwise, proceed with Step
4.
Configure an IP address on the interface.
4.
On ERX7xx models, ERX14xx models, and the ERX310 router:
Copyright © 2010, Juniper Networks, Inc.