Defining A Boolean Test - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide
170
host1(config-mgmtevent)#
NOTE: Once enabled, you cannot edit an event or trigger configuration.
To change an enabled event or trigger, you must delete it and re-create
it.
Define the trigger that you want to use for an event by specifying a trigger owner and
6.
trigger name.
host1(config-mgmtevent)#trigger george trigger1
host1(config-mgmtevent-trigger)#
Specify a MIB object to sample.
7.
host1(config-mgmtevent-trigger)#sample value-id 1.3.6.1.2.1.60.1.2.1.1.7
Specify the frequency (in seconds) at which you want the sampling to occur.
8.
host1(config-mgmtevent-trigger)#frequency 100
NOTE: Unless you specify that you want to perform delta sampling, the
values are absolute.
(Optional) Specify that you want to perform delta sampling on the sample value ID.
9.
host1(config-mgmtevent-trigger)#delta-sampling
(Optional) Enter the discontinuity MIB value ID that you want to test.
host1(config-mgmtevent-trigger)#delta-sampling discontinuity-id
1.3.6.1.2.1.31.1.1.1.19.9
(Optional) Enter the discontinuity type (timeStamp or timeTicks) that you want
the test to use.
host1(config-mgmtevent-trigger)#delta-sampling discontinuity-id-type timeStamp
(Optional) Configure the desired SNMP security level for the agent that you want to
10.
poll.
host1(config)#snmp security read
Define the test values that you want this trigger to use.
11.
You can define a Boolean test, existence test, or threshold test. See the following
sections for procedures.

Defining a Boolean Test

You can configure a Boolean trigger to test whether the value of an integer object is equal,
unequal, greater than, less than, less than or equal to, or greater than or equal to some
defined value.
To define a Boolean test:
Define the Boolean-test comparison that you want this trigger to use.
1.
Copyright © 2010, Juniper Networks, Inc.