Address Dead-Interval - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

address dead-interval

[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
dead-interval deadInterval
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the time period that the router's neighbors should wait without seeing hello
Description
packets from the router before they declare the router to be down. The no version
resets the dead interval to its default.
NOTE: You must issue the address area command before issuing this command.
Options
Router Configuration
Mode
94
address dead-interval
ipAddress OSPF interface address previously specified with the address
command
unnumbered Indicates that OSPF is running on an unnumbered interface
previously specified with the address command
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
deadInterval Number in the range 0–2147483647 seconds; default value is 40
seconds