Configuring Overriding Profile Assignments For Vlan Major Interfaces - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
5.
6.
7.
8.

Configuring Overriding Profile Assignments for VLAN Major Interfaces

You can assign an overriding profile to a single VLAN major interface within a
bulk-configured VLAN subrange.
The overriding profile includes debugging attributes to help you identify and
troubleshoot problems with the VLAN dynamic subinterface column created on the
specified VLAN ID.
To assign an overriding profile to a VLAN within a bulk-configured VLAN subrange:
1.
2.
3.
670
Configuring VLAN Dynamic Subinterfaces
Configure the VLAN major interface.
host1(config)#interface gigabitEthernet 5/0
host1(config-if)#encapsulation vlan
On the VLAN major interface, configure a VLAN range that is based on
agent-circuit-identifier information, and assign a name to this range.
host1(config-if)#vlan bulk-config myNewBulkConfig svlan-range 50 100
agent-circuit-identifier
Assign the base profile configured for the VLAN subinterface to the VLAN range
configured on the major VLAN interface.
host1(config-if)#profile vlan bulk-config myNewBulkConfig vlanMyBaseProfile
Configure the VLAN major interface to support autodetection of the VLAN dynamic
encapsulation type.
host1(config-if)#auto-configure vlan
Configure both of the following:
Base profile for the bulk-configured dynamic VLAN on the static VLAN major
interface. The VLAN range consists of one or more VLAN subranges.
Overriding profile for a dynamic VLAN within a bulk-configured VLAN
subrange.
For information about configuring profiles, see "Configuring a Dynamic Interface
from a Profile" on page 563 in "Configuring Dynamic Interfaces" on page 515.
Create a bulk-configured range of single-tagged VLAN IDs or double-tagged
S-VLAN IDs on a static VLAN major interface. The following commands create
a bulk-configured VLAN range named myBulkConfig that consists of two VLAN
subranges. The first subrange encompasses VLAN IDs 150–250. The second
subrange encompasses VLAN IDs 300–500.
host1(config)#interface gigabitEthernet 4/0.101
host1(config-if)#vlan bulk-config myBulkConfig vlan-range 150 250
vlan-range 300 500
Assign the previously configured base profile (vlanBaseProfile) to the
bulk-configured VLAN range.