urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 552

Mode 2: factory reset with call button (Modular Entry Panel with 1060/48 OFF)
Press the call button on the right (indicated in the figure with the red circle) of the Outdoor Audio and Video
IP Station 1060/48, turn on the device by continuing to hold down the relevant button until the orange
LEDs begin to flash 6 times. You can now release the call button. After about 1 minute, the white LEDs
illuminating name tags and buttons start flashing: this means that the factory reset operation has been
carried out correctly.
Figure 697: front view of Outdoor Audio and Video IP Station 1060/48
Mode 3: factory reset with call button and entrance hall button (Modular Entry Panel with 1060/48 ON)
Press the call button on the right of the Outdoor Audio and Video IP Station 1060/48 (the same as in the
previous mode) and at the same time the entrance hall button (for about 20s) until the orange LEDs start
flashing 6 times. You can now release the call button and the entrance hall button. After about 1 minute,
the white LEDs illuminating name tags and buttons start flashing: this means that the factory reset
operation has been carried out correctly.
552 MT124-032N