urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 762

1. ROUTER 1
• Enable the DHCP Server and ensure that it assigns addresses of the 10.2.1.x/24 type;
• Set the WAN port in DHCP.
2. ROUTER 2
• Enable the DHCP Server and ensure that it assigns addresses of the 192.168.88.x/24 type;
• Connect the WAN port to Internet (optional).
3. NVR Urmet device
• Set the WAN port in DHCP;
• Disable the DHCP Server on PoE interface.
4. RTSP Cameras
• Set the RTSP Cameras addressing in static mode with addresses of type 10.10.1.x/24.
In this way the IPerCom devices connected to ROUTER 1 via LAN will have addresses of the type 10.2.1.x/24
while the WAN port of ROUTER 1 and the WAN port of the Urmet NVR device will have IP addresses of the
type 192.168.88.x/24. Furthermore, the RTSP Cameras connected to the LAN ports of the Urmet NVR
device will have static IP addresses of the 10.10.1.x/24 type.
From the configurator's point of view, for each RTSP Camera physically connected to the Urmet NVR device
it is necessary to add a device of the "RTSP camera (NVR)" type from menu "Other Devices", as shown
below:
762
Figure 817: "RTSP Camera (NVR)" device
MT124-032N