urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 60

Press "OK" to select the network interface through which the PC is connected to the IPerCom system, as
shown in the following screen:
The button allows updating the list of available network interfaces.
To know the IP and MAC addresses of the network interface through which you are connected to the
IPerCom system, it is necessary to press the "Open Network Connections and Sharing Centre" button
on your PC (icon
connected to IPerCom system. Press the left mouse button on the network item in question, to
display a screen with the "Details" button, where the IP address and MAC address are shown.
After selecting the correct network interface, the "Connect" button detects the IPerCom devices connected
to it with their firmware version (after checking if the system is with or without server).
After pressing the "Connect" button, the Windows operating system can notify the user of the need
to unlock the communication ports on the IP network used for communication between the IPerCom
system and the IPerCom Installer Tools application. This operation is required for proper application
operation. If this operation is carried out by Windows Firewall, a warning like the one below is
shown to the user:
You must select both kind of networks and press the "Allow access" button.
60
Figure 15: selecting the network interface
at the bottom right of the screen), then identify the name of the network
MT124-032N