urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 179

If the number of devices, apartments, and users is less than or equal to 1000 and you want to switch to a
system without Server 1060/1, the operations to do are as follows:
•
disconnect the various servers from the system;
•
start IPerCom Installer Tools (if already started, close and start the application again);
•
open the project associated with the system;
•
connect to the system;
•
enter the "Maintenance" tab.
The screen displayed is as follows:
As you can see, IPerCom Installer Tools detects that the system is without server, because the various
servers have been disconnected from the system. However, to complete the operation correctly, it is
necessary to press the "Force Mode Without Server" button (which was frozen in the previous screen). The
following message is displayed:
MT124-032N
Figure 184: "Maintenance" tab - operation without server
Figure 185: request to restore the mode without server
179