urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 111

After entering the correct password, the configurator opens the relevant project:
After saving the configuration and exiting the configurator (see paragraph
configuration"), the way the configuration is transferred to the system is like the previous case.
If you import a configuration file onto another PC and this configuration has already been applied on a
system, it is absolutely forbidden to transfer it to another system. The import function can be used (for
example) to pass a project from one installer to another, assuming that both installers work on the same
system.
6.10 How to use IPerCom Installer Tools to edit the configuration with system already
installed and configured
When a system has been installed and configured, it may be necessary to modify its configuration for
various reasons (that is change of topology, change of system parameters or addition of devices). The
various steps to follow to modify the configuration of a system with IPerCom Installer Tools are described
below:
•
open the project connected to the previously configured system;
•
make the required modifications;
•
connect to the system;
•
distribute the newly modified configuration to the system.
A variant of this procedure can be to connect to the system and then make the modifications: the
advantage of this procedure is that, if new devices must be added, it is not necessary to know their MAC
addresses, as these are automatically proposed by the configurator, which is not the case if you are not
connected to the system. In this way it is also possible to check that the dates of the last modification of
project and system are aligned and therefore be sure that you are starting from an already aligned
situation.
MT124-032N
Figure 81: configuration of the imported file
"How to save the
111