urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 774

APPENDIX Q: First upgrade of a system via Server 1060/1
To upgrade a system (just installed and not configured) to version 2.1.2 via Server 1060/1, follow the steps
below:
•
using IPerUpgrade, upgrade the Server 1060/1 (or Servers 1060/1) to the required IPerCom
firmware version (IPerUpgrade application and user manual available at www.urmet.com);
The Servers 1060/1 are upgraded on a network where, in addition to the Servers, there is only one
PC where the IPerUpgrade application is installed.
•
use IPerCom Installer Tools to create a project and connect to the system;
•
from the "Configuration" tab press the "Create" button to create a new configuration and choose
the system topology;
•
add the Servers 1060/1 to the configuration via the "Devices" tab and the "Add new device" button;
•
in the Server configuration page assign a name to the device and associate the MAC address
through the button in the red box:
•
in the "System" tab under the "Maintenance Settings" section, enable the "Automatic Server
Upgrade" item:
774
Figure 825: IperCom Server 1060/1
MT124-032N