urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 659

APPENDIX G: Changing the network settings of IPerCom Installer Tools.
If it is necessary to change the network settings of the system after its commissioning, this is possible in the
configurator through the System tab in the Network Settings section, which allows you to switch from an
automatic setting (for example if there is a router in the system) to a manual setting or vice versa. In both
cases the settings of the network card, through which the PC connects to the system where the IPerCom
Installer Tools application is installed, need some modifications to continue to connect to the system. To
make the task easier for the installer, the IPerCom Installer Tools application, through an interactive
dialogue box, indicates which modifications need to be made.
For example, if you switch from an automatic network setting to a manual network setting with the
following parameters:
Figure 785: changing the network parameters
After saving the configuration, exiting the configurator, and applying the modifications to the system,
IPerCom Installer Tools shows the following message:
Figure 786: message on the modification of network parameters
At this stage some devices may reboot because of the IP address change.
MT124-032M 659