urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 494

8.3 System first configuration
This section describes the steps to be followed when configuring an IPerCom system for the first time
referring both to the MAX, VOG
When doing this, all devices must have the factory settings; otherwise, it is necessary to reset to the factory
settings (see chapter Restoring the factory
After setting the date and time, the next step is to create the configuration, which includes the following
points:
1. definition of the system topology,
2. addition of the devices to the configuration,
3. creation of the directories,
4. creation of activations,
5. creation of residents and non-residents,
6. setting of the access control,
7. configuration of the system parameters and call forwarding.
Once the configuration is finished, it is necessary to distribute it to the various devices of the system, export
it to SD card and as last step to secure the system.
We recommend to pay particular attention to the system date and time setting phase, which must
be carried out before any other step.
We recommend to distribute the configuration to the system only after waiting at least 10 minutes
from the connection of the last device.
The IPerCom Configurator app can create the configuration but not to distribute it to the other
devices in the system or secure the system.
494
7
or Basic video door phone and to the IPerCom Configurator app.
settings).
MT124-032N