urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 765

APPENDIX N: "Site name" and "Global site ID" field definition
The site represents the system you want to configure, meaning for system the entire network, devices and
IPerCom software applications. It is possible to assign a name to the site and this is a fundamental data
because it allows the site to be uniquely recognized in all the possible applications in which it is involved.
The applications in question are the following:
- the configurator, where when creating a new project, you must enter the name of the site;
- IPerCom Installer Tools, where the name of the site given in the configurator is visible in the "Site"
tab on the right side of the screen,
- CallMe Manager, where the name of the site appears in the list of sites managed by the building
manager.
The CallMe Manager application is present only if the relevant item is enabled in the configurator: in this
case the "Global site ID" parameter also comes into play, as explained after.
Below are the right steps to fill in the "Site name" field.
When creating a new project, IPerCom Installer Tools shows the following screen (after connecting to the
system to be configured):
The "Site name" field has not yet been filled in.
MT124-032M
Figure 819: "Site name" field not filled in yet
765