Download Print this page

urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 285

Advertisement

By selecting an apartment in the navigation module, in correspondence of the "Activations" tab we will see
the activation applied by the stair node, as shown in the following figure:
Figure 330: Activation "inherited" from the apartment
The activation is greyed out to show that it was created on the stair node, not on the apartment node.
Therefore, it can only be modified by going to on the stair node and not to the current topological node.
If you want to replace the activation on the apartment with a custom one, just press the replacement
button and change the data.
Assuming you want to change the Relay Actuator output from "Output 2" to "Output 1" in the previous
created activation, a screen like this will appear (the activation rule is no longer greyed out):
Figure 331: Replacement of the activation on the apartment with a personalised one
MT124-032N
285

Advertisement

loading
Need help?

Need help?

Do you have a question about the IPerCom 3.1.0 and is the answer not in the manual?