urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 582

End user settings
Integrated call buttons
Camera LEDs
Welcome Message
Call Feedback
Voice synthesis module
Twilight sensor
Screen Saver operating mode
Module configuration
LCD menu items
582
The 2 calling station buttons can be enabled or disabled as
shown below:
-) both disabled,
-) only right call button enabled,
-) both enabled.
Enabling of the camera LEDs. Default value: selected.
It allows you to enter a text message that will be displayed
on the display module 1168/1 in case of configuration as
Alpha call module.
This allows you to set call feedback via vocal message/sound
feedback or to set no call feedback mode (default).
It allows you to set up call feedback via voice message or
audible feedback. Default value: selected.
It allows you to enable or disable the twilight sensor present
on the module. Default value: not selected.
It allows you to enable and configure a screen saver on the
Display Module 1168/1 when in stand-by mode. Use modes are:
-) OFF (screen saver disabled),
-) alternating between home page and screen saver,
-) continuous operation.
It allows you to select and enable the various modules that
make up the calling station:
-) Numeric Keypad Module 1168/46,
-) Alphabetic Keypad Module 1168/49,
-) ILA Voice Synthesis Module 1168/48,
-) Display Module 1168/1,
-) Proximity key reader 1168/45.
It allows you to select which items will be displayed on the
Display Module 1168/1:
-) call from address book,
-) call through manual code,
-) door/gate opening,
-) activation through code,
-) call to the switchboards concerned,
-) empty line.
Table 41: end user settings
MT124-032N