urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 120

If you create a configuration file with an identifier other than 1689259875 (which is the right system
identifier), i.e. with a creation date other than ''16/06/2023 16:52:42'', and if you are not yet connected to
the system (which has the same identifier as the local site "1637772037"), the following situation occurs:
Figure 94: "Site" tab with project identifier different from that of the system site
As shown in the figure above, the project identifier is different from 1689259875. If you connect to a
system already configured and working (with identifier 1689259875) and try to apply this configuration,
you could inevitably lose the work already done. To avoid this, when the local identifier does not coincide
with the system identifier (that is with system already configured), after pressing the "Connect" button, the
following message is displayed:
Figure 95: error message if project identifier and system site identifier do not match
Press the "OK" button to close the application and open it again on the "Site" tab with no project open.
The only way to connect to the system is to load the project connected to this system: the correct use of
the application requires in fact to have a unique project for each system from which to connect to the
system and make the modifications.
120 MT124-032N