urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 519

8.7.2 How to change the configuration
The configuration of a system can be changed in different ways:
1. by updating the users from the Switchboard application installed on the system;
2. by opening the configurator from the configuration menu of a MAX, VOG
phone installed in the system;
3. by exporting the system configuration to the SD card, by modifying the file in the office from the
configurator for MAX, VOG
system.
While the first mode is performed by the Switchboard operator, the other two are used by the system
installer.
To change the current configuration of a system, access the configuration menu of a properly configured
7
MAX, VOG or Basic video door phone belonging to the system, then select "System configuration" and
"Edit current configuration": once the installer password has been entered, the configurator will open in
the "Topology" tab, as shown in the following figure:
Once the necessary changes have been made, to distribute the configuration to the system, select the
"Project" tab and press the "Apply" button.
The modification of the current configuration from a MAX, VOG
via the Switchboard affect the current configuration of the system. If on the other hand you decide to use
the last mode, i.e. changing the configuration in the office via MAX, VOG
phone/PC/Android tablet, you must consider that the change is not applied to the current configuration of
the system, but on the latest version exported to SD card.
MT124-032N
7
or Basic video door phone/PC/Android tablet and by importing it to the
Figure 654: How to change the current configuration
7
7
or Basic video door phone and that made
7
or Basic video door
or Basic video door
519