urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 297

7.1.5.8.5 Activations for topological events with 2Voice audio/video apartment stations
Activations for topological events also apply to topological stair nodes with 2Voice Gateway with the
following differences:
1. The User Activations - MAX, Lift Down and Lift Up events are not present on the nodes below a stair
node with 2Voice Gateway:
The events in question are instead present on each stair node with 2Voice Gateway, because on these
nodes it is possible to add other IPerCom devices (e.g., one or more MAX, VOG
where it could be necessary to create activations related to these events):
2. User Activation - Door Phone T1 and User Activation - Door Phone T2 events do not refer to buttons
T1 and T2 of the Door Phone 1160/3 or 1761/6 video door phone and correspond to the pressing of
two specific buttons of the 2Voice audio/video Door Phone that activate special function 7 (T1) and
special function 8 (T2) (under certain conditions) instead. Only these two special functions are
correctly interpreted by the gateway and sent to the Relay Actuator 1060/84. Refer to the
individual instruction manuals of 2Voice Door Phones for more details on the buttons which
activate these special functions and under which conditions these buttons must be pressed.
The activation rule, if set on apartment level, will only apply to the individual apartment. This allows you to
have different activation rules on individual apartments located on the same gateway.
If set on site or block level, the activation rule is inherited by the 2Voice apartments and by apartments
with IPerCom Door Phones. It is always light grey (to highlight that it was not created in the apartment
node):
MT124-032N
Figure 347: List of events for audio/video Door Phone 2Voice
7
or Basic video door phones
297