urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 751

At this point, from a PC with an IP address in the same subnet as the IPerCom system, enter the IP address
reported in the Device Config Tool application in the address bar of the browser. After entering the
username and password, you can connect to the Urmet NVR device again.
In the "Network" section, press on the "General" item to view the IP address of the WAN port, network
mask and gateway (like what is reported by the Device Config Tool application):
Figure 802: tab "Remote Setting" - section "Network" --- > "General"
MT124-032M 751