urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 310

To build the group of commands press the "Add New Output" button. The following page will appear:
Figure 364: Creation of a group of commands
First, you need to give a meaningful name to the group of commands, then add the outputs you want them
to be part of the group. To do this, press the "Add a New Output" button. A screen will open. Go to the
topological node of the Relay Actuator, select the concerned device, then choose the output and set the
respective command:
Figure 365: First output selection with scenario command
310 MT124-032N