urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 602

Hall Button Settings
Remote Button (#)
Gate settings
Used
Gate Profile (#)
Gate Name (#)
Gate Opening Time (s) (#) (§)
Gate Under Secret (#)
602
It allows you to remotely control the entrance hall button
that opens the main door of the Call Module. For further
details, see paragraph
entrance hall button and remote
Table 57: Hall button settings
In this case, the item Yes enables the gate: the following
options are shown, marked with a hash mark (#). The item
No disables the gate. The item "By door opening" allows you
to use the relay contact of the gate to open the main door.
The Relay Actuator item allows you to use the gate relay
output as the output (only in monostable mode) of a Relay
Actuator: in this case the item marked with the symbol (§)
appears. For further details see the section
used as output of a Relay
It allows you to associate a previously created access profile
to the gate in question. In this case the gate parameters are
automatically filled in (except the name). Default value:
customised (the parameters must be filled in manually).
Name to assign to the gate.
Pulse duration on the control relay. Default value: 3s.
Allowed values: from 1s to 90s.
If selected, by pressing the gate button (from an indoor
station) it is possible to activate electric lock of the outdoor
station only when the caller is in conversation or is waiting
for a response. If not selected, the gate can also be opened
outside the call phase from all the apartments where the
topological path detects the outdoor station. Default value:
selected.
Table 58: Gate settings
Remote relay functions, remote
sensor.
Gate contact
Actuator. Default value: No.
MT124-032N