urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 206

7.1.2 Adding devices
Once the topology has been defined, it will be possible to add the devices in the system configuration.
There are 3 different ways to configure the devices, depending on whether you are connected to the
system via PC.
In any case, regardless of the chosen installation mode and topology, it is necessary to associate each
device to a topological node, bearing in mind that:
•
calling stations (except Private Call Module 1060/22) and Switchboards cannot be associated to an
apartment node;
•
Private Call Module can be associated only to an apartment node;
•
the IPerCom-2Voice Gateway and the Lift Interface can only be added to a stair node.
The apartment stations are not subject to any rules and therefore can be associated with any topological
node, therefore also with nodes such as site, block, stair, or floor. This is useful if you want to provide a
"calling station" in a "Swimming pool" room associated (for example) with a stair node: by positioning a
video door phone on this node it is possible to call the Switchboard or be reached by calls from the
Switchboard or from the apartments.
The "IPerCom Clock Module", where applicable, must be added in the configuration as every other device
and can be positioned in any topological node of the system.
The device can be configured in 3 ways, as briefly described below.
The first method should be followed if you are not yet connected to the system, the others if you are
connected to the system. In all cases, go to the "Topology" tab and then to the "Devices" tab.
206 MT124-032N