urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 204

7.1.1.4 Multi Block systems
The last type of plant model supported by the configurator is the Multi Block one, that allows creating a
project with any number of blocks/stairs/floors/apartments.
The selection of Multi Block as plant model automatically leads to the creation of a site without blocks, as
shown in the following figure:
Figure 219: "Topology" tab for Multiple Block system
As in the previous cases it will be possible to add all the blocks with their stairs/floors/apartments with a
single command.
Figure 220: adding of new blocks to the topology
If the topological structure of the system is not homogeneous, it will be possible to add/remove
blocks/floors/stairs/apartments later.
204 MT124-032N