urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 226

Tick the "Customise" box to enable the relays to every single path created between the lift interface and
the various devices.
7.1.2.2.3 Lift interface-RS485 mode
The Lift Interface-RS485 type allows interfacing the device with a possible third-party controller. In this
case the lift interface will only communicate the event occurred in the system to the third-party controller
that will perform the actions programmed according to the above event.
7.1.2.2.4 Relay Actuator Mode
The "Relay Actuator Mode" type allows the lift interface to be used exactly like a Relay Actuator 1060/84
but with 24 outputs. For relay operation and configuration, see paragraph
parameters of IPerCom
226
Figure 251: Lift Interface assignment - Enabling non-resident user relays (part 2)
devices".
"APPENDIX A: Configuration
MT124-032N