urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 224

7.1.2.2.1.4 Assignment in Apartment mode
In this case the assignment operation is carried out through the settings of each apartment, it is necessary
to first select the desired floor, choose the lift interface to configure and finally enable the relays to be
activated.
Figure 247: Lift Interface assignment - Apartment selection
Figure 248: Lift Interface assignment - Enabling control relay in Apartment mode
As in the case described above, this operation must be repeated for each apartment. The figures above
show for example the activation of relay 1 in case you want to enable the lift on Apartment 1.
Each lift interface acts exclusively within the block/unit to which it is associated, so the apartments
to be selected will only be those relevant to its block and unit.
224 MT124-032N