urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 221

To create a path, it is necessary to select an access available in the system from the list. The types of
devices that can be selected are:
•
Call Module 1060/12-13-17-18-23,
•
Modular Calling Station with 1060/48,
•
Entry panels 1060/21-33-34-71-74-75,
•
Key readers 1060/45,
•
Key readers 1060/86,
•
Switchboard 1060/41.
Then it is necessary to set the activation time of the relays associated with the path. The following options
are possible:
•
"15 seconds",
•
"5 minutes",
•
"Unlimited",
•
"Customized".
In the last case it is necessary to specify the duration in seconds for which you want the relays to remain
energised.
7.1.2.2.1.2 Control Relay Assignment
The configuration of a lift interface is completed by assigning the control relays to the floors/apartments
concerned. The way to make the assignment is the same whether it is used in "Floor" or "Apartment"
mode, what changes is the section where the configuration is made: in the first case within the floor, in the
second case within the apartment. Basically, it is necessary to match each floor/apartment you want to
enable with the switching of one or more relays necessary to allow the lift to rise.
The possibility to activate even more than one relay for each floor/apartment is present to make
complex selections, if required by the lift control panel (e.g. enabling via a multi-digit binary code).
MT124-032N 221