urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 488

To finish the installation correctly, it is necessary to press the "END" button, which brings back to the initial
screen of the IPerCom Configurator app. The "Open" button does not allow you to launch the newly
installed configurator version as this can be done only from the IPerCom Configurator app (by opening a
configuration file or creating a new one).
After the installation, the "Settings" button shows the installed configurator versions for the released
IPerCom versions, as shown below in the red box:
Figure 616: list of configurators installed and not installed
By pressing the "OK" button, the "New" and "Open" buttons are active:
Figure 617: "New" and "Open" buttons active
488 MT124-032N