urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 338

In the same way, it is possible to remotely control the pedestrian door entrance hall button or the open-
door sensor with the only difference that, instead of selecting the output of a Relay Actuator, it is necessary
to select an input. The remote entrance hall button will activate (for a pre-set time) the same output used
to remotely control the pedestrian passage.
The "Remote Button" item for hall button is always found on the configuration page of the Call Module in
the section relating to the hall button.
If the pedestrian door is remote-controlled, the relevant entrance hall button, if not remote-
controlled, does not activate the output of the Relay Actuator connected to the pedestrian door.
The choice of the outputs or inputs through which you can remotely control the pedestrian door or
driveway or the entrance hall button can also be made on the Lift Interface device when this is used
in Relay Actuator mode.
The relay output used to remotely control the pedestrian door of any call station cannot be used for
other activation rules.
The remote setting of an entrance hall button must always be associated with the remote setting of
the relevant pedestrian passage.
The remote setting of a driveway is done in the same way as for a pedestrian passage, the only
difference is that for the driveway there is no entrance hall button and the relevant door open
sensor.
338 MT124-032N