urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 394

7.1.10.8 Sunrise/Sunset Settings
The parameters are shown in the following figure:
The parameter meaning is as follows:
City The value chosen in this drop-down menu allows you to set automatically the
"Latitude" and "Longitude" values used to calculate the sunrise and sunset time
to program the activation of the outputs of one or more Relay Actuators or one
or more scenarios on a weekly basis.
Latitude Value calculated automatically according to the city chosen in the previous menu.
The value can also be set manually if no value is set in the previous menu.
Longitude Value calculated automatically according to the city chosen in the previous menu.
The value can also be set manually if no value is set in the previous menu.
394
Figure 488: "System" tab - "Sunrise/Sunset Settings"
Table 23: meaning of the parameters in the "Sunrise/Sunset Settings" section
MT124-032N