urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 151

Then with app CallMe scan the QR code displayed on the PC where the IPerCom Installer Tools application
is installed. After scanning the QR code, the following screen will appear on your smartphone/tablet to
indicate that the place has been added correctly:
The default name given to the place is "IPerCloud Test" but it is possible to rename it (even later): at this
point the CallMe app has been associated with a (not real) IPerCloud test apartment. The installer can
therefore make a call from any calling station to the IPerCloud test apartment: in fact, on all calling stations
with display the relevant address books show only the name "IPerCloud Test" while calling stations with
buttons call the "IPerCloud Test" apartment (from any button).
Address books present on the calling stations with displays will appear again after disabling the test
mode from the configurator.
In test mode the installer can only do the following:
•
call the test IPerCloud apartment from any calling station,
•
check that the call arrives to the CallMe app;
•
answer the call by checking the correct presence of audio and video;
•
open the doors (main door and gate) only during conversation;
•
auto-insertion on calling stations.
The test mode can therefore be considered passed if the points listed above work correctly.
In test mode from the CallMe app it is not possible to open the doors (main door and gate) outside
of a call and it is not possible to activate any user activation.
MT124-032N
Figure 140: place added
151