urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 603

End user settings
Call Feedback
Loudspeaker Volume
Camera LEDs
RTSP In-Call stream settings
RTSP In-Call stream
IP Address (#)
Network mask (#)
Port
Stream
User Name (#)
Password (#)
URI for Streaming
In the RTSP streaming settings to set the IP address it is recommended to follow what is reported in
APPENDIX F1: How to use customized network settings in IperCom
It is possible to configure any Urmet NVR device to record calls made via Entry Panel 1060/34 and
related auto-on activated by video door phone. In
calling stations to NVR Urmet
shown. For the configurations of the other Urmet NVR devices contact the Urmet Service Centre.
MT124-032N
This allows you to set call feedback via vocal message/sound
feedback or to set no call feedback mode (default).
Loudspeaker volume setting.
Enabling of the camera LEDs. Default value: selected.
Table 59: End user settings
If selected, the Switchboard application can display the RTSP
video stream of the calling station during the call to an
apartment station or during the auto-on from an apartment
station. Fields marked with the hash mark (#) must be filled
correctly.
IP address of calling station camera
Subnet mask of RTSP cameras (including calling station camera).
RTSP video stream port. Value not editable.
Name of the RTSP video stream. Value not editable
Username to access the calling station RTSP video stream
from the Switchboard application.
Password to access the calling station RTSP video stream
from the Switchboard application.
Full URI of the RTSP video stream. Value not editable.
It is built automatically by filling in the fields above respecting
the following syntax:
rtsp://[<username>:<password>@] <IP address>:<port>/<stream>
Table 60: RTSP streaming settings
APPENDIX M1: Streaming video from IPerCom
the configuration procedure of the 1098/328P Urmet NVR device is
system.
603