urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 52

In both above cases, the Switchboard and IPerCom Client applications, assuming they are each
running on different PCs, are automatically upgraded (by IPerUpgrade or by Server 1060/1). From
version 3.1 the update of the IPerCom Client application is performed correctly even if you do not
have administrator rights on the PC.
In both the above-mentioned cases the firmware of the following devices does not require an
upgrade: Relay Actuators, Key Readers, Lift Interface, iPassan Controller, IPerTalk Server and RTSP
Cameras.
It is essential that all devices and/or applications (IPerCom Installer Tools and Switchboard) are aligned to
the same IPerComversion, otherwise the proper system operation is not guaranteed.
The possible presence of a misalignment between the IPerCom versions of the devices and/or applications
is signalled by the IPerCom system via:
•
IPerCom Installer Tools application,
•
video door phone,
•
iPerCom Client application,
•
Switchboard application.
The check is not actually done on the IPerCom version but on the software development platform version
(UPTK) incorporated into the same IPerCom version: in general, the presence of different UPTK versions
implies the presence of devices/applications with different IPerCom versions in the same system.
In all the three cases mentioned above a list of software devices/applications whose UPTK version is not
aligned with the local UPTK version of the device/application that reported the misalignment is shown.
The mode in which this is reported is explained in detail in the dedicated paragraphs
to the same IPerCom or software development platform (UPTK) version
same IPerCom version or UPTK software development
IPerCom Installer Tools and to the video door phones of the IPerCom system. As regards the IPerCom Client
and Switchboard applications, please refer to the relevant manual available on the website
www.urmet.com.
If there are no video door phones in the system, the IPerCom Installer Tools or Switchboard or
IPerCom Client application must be used to detect the presence of devices and/or applications with
misaligned IPerCom versions.
52
and
platform) in the sections relating respectively to
(Devices not aligned
Devices not aligned to the
MT124-032N