urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 479

The time zone setting will be applied only to the current device. The time zone of the whole system is
selected during configuration, as shown in paragraph System parameters.
7
Therefore, in addition to setting the time zone using the MAX, VOG or Basic video door phone as shown, it
is also recommended to confirm your selection of the time zone using the configurator, so that the entire
system is set to the desired date and time.
As shown above, the screen for editing date and time automatically opens when the configuration menu is
accessed. To open it again after setting the date and time, go to "System configuration" in the configuration
menu and then click on "Change system date and time".
7
If the generic MAX, VOG or Basic video door phone has been configured, i.e. is set to the time zone in
common to the whole system, it is not possible to change the time zone using the window shown in Figure
(the respective section will be disabled). In this case, to make a change, you will need to change the system
configuration as shown in paragraph System parameters.
8.1.2 Configuration menu
After setting date and time the configuration menu will appear as shown in the following figure:
Figure 602: The configuration menu
The configuration menu is divided into two sub-menus: "System configuration" and "SD card projects
management".
MT124-032N 479