urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 507

Configuration file extension: when saving the configuration you must assign a name to the file
created; the default name of the file is "ipercom.ccf", but it can be changed by the user only by
paying attention to always add the extension ".ccf" at the end of the name (otherwise the
configuration cannot be imported from the MAX monitor.
Removing the SD card after saving): After you have saved the configuration via Android Tablet, to
prevent the configuration file from being corrupted, it is advisable to remove the SD card before
removing it from the device.
8.3.2.4 Mode 3: The installer creates the configuration in the laboratory on the MAX video door
phone/PC/Android tablet and adds at the same time the devices that are not yet installed
Application case: The devices are still in stock (therefore neither installed in the system nor
configured): the configuration is created entirely in the laboratory taking note of the
position of the devices and their MAC address.
Pros: It is possible to create the topology in the laboratory on a PC and add devices (of any
type) by manually entering their MAC address or by scanning the QR Code.
Cons: Care must be taken when noting the devices arrangement in the system.
In this case, the installer has the devices not yet installed in the system and prepares the configuration
offline in the laboratory via MAX video door phone/PC/Android tablet.
1. Configuration creation (topology only) in the laboratory and export to SD card
The installer creates the configuration in the laboratory on the MAX video door phone/PC/Android tablet by
initially setting only the system topology.
2. Addition of the devices to the configuration directly in the laboratory, before their installation on
the system
When the devices are available, it is possible to add them to the configuration as usual, by manually
entering the MAC address indicated on the package or, if using an Android tablet, by scanning the QR Code,
as described before.
The only thing we suggest to pay attention to, is to write down the position in which each device is to be
installed.
MT124-032N 507