urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 322

7.1.5.9.5 Creation of relay actuator activations and alarms
The activation and alarm generation rules seen in the previous paragraphs can also be created on the
configuration page of the relay actuator in the section dedicated to inputs.
Note that the input programming method described in the previous paragraphs is only possible on relay
actuators with firmware version 3.04 or higher. If the firmware version is 2.07, the inputs are not
programmable and therefore the following is not valid.
The section relating to the inputs (both input 1 and input 2) of a Relay Actuator is as shown below (if no
name has been given to the inputs yet):
Figure 388: Input configuration of a relay actuator ver.3.04
The "Activations" and "Alarms" buttons can be used to create that described in the previous paragraphs but
only for the concerned input. Press the "Activations" button to open the following page:
Figure 389: Adding relay actuator input activations
322 MT124-032N