urmet domus IPerCom 3.1.0 System Technical Manual For The Installer page 102

6.9.6 Connecting to the system and transferring the configuration
Once the configuration associated with the project has been created and defined (backup or the most
recent one), the next step is to connect to the system site and apply the newly created configuration to it,
to configure the system. The relevant box on the "Site" tab shows values that are all unavailable because
the system status is still offline (
To connect to the system, select the network interface through which the PC is connected to the IPerCom
system in the lower part of the red box and then press the "Connect" button.
To find out the IP and MAC addresses of the network interface through which you are connected to
the IPerCom system, you need to click on the item "Open Network and Internet settings", which
appears by pressing the right mouse button the icon
A screen opens with the list of available networks. After pressing the corresponding "Properties"
item, you can view the IP address and MAC address.
102
), that is you are not connected yet:
Figure 69: "Site" tab with local configuration created and no connection to the system
at the bottom of right on your PC monitor.
MT124-032N