Table of Contents
Advertisement
5 Repair
5.5.1 Replacing the inner arm
Continued
Securing the process hub to outer arm cover
1
2
3
4
Refitting the axis-1 cover
1
2
Continues on next page
264
Action
Install a screw to the reserved hole on the process
hub.
Grip the screw to install the process hub.
Secure the process hub to the outer arm cover
with the screws.
CAUTION
Be aware of the cabling that is attached to the
cover! The cover can not be removed completely
until the connectors are disconnected, as shown
in following steps.
Remove the screw.
Action
Refit the cover.
Refit the screws.
© Copyright 2023 ABB. All rights reserved.
Note
Screws: Hex socket head cap
screw M4x12 12.9 Lafre
2C2B/FC6.9 (4 pcs)
Tightening torque: 2.4 Nm ±10%
For robots with protection class
IP30 (option 3350-300)
xx2300000487
Note
Screw: Hex socket head cap screw
M4x10 12.9 Lafre 2C2B/FC6.9 (6
pcs)
Tightening torque: 2.4 Nm ±3%
For robots with protection class
IP30 (option 3350-300)
xx2300000498
Product manual - IRB 930
3HAC086009-001 Revision: A
Advertisement
Table of Contents
