Print Command Late Rap - Xerox WorkCentre 5687 Series Service Manual

03-423, 424, 433, 434, 821, 822, 831, 832 Print Command
Late RAP
03-423 The IOT detected print command late with respect to page sync in simplex 3 mode.
03-424The IOT detected print command late with respect to page sync in simplex 4 mode.
03-433 The IOT detected print command late with respect to page sync in duplex 3 mode.
03-434 The IOT detected print command late with respect to page sync in duplex 4 mode.
03-821 The IOT detected print command late with respect to page sync in simplex 1 mode.
03-822 The IOT detected print command late with respect to page sync in simplex 2 mode.
03-831 The IOT detected print command late with respect to page sync in duplex 1 mode.
03-832 The IOT detected print command late with respect to page sync in duplex 2 mode.
Procedure
These codes record events in the fault history file, but do not prevent the machine operating
normally. These faults will also result in a blank sheet being delivered to the output tray.
Delete the job and switch off the machine, then switch on the machine, GP 14. If the fault is still
present, go to the 06-340 ROS Laser Failure RAP.
Status Indicator RAPs
03-423, 424, 433, 434, 821, 822, 831, 832, 03-480
03-480 IOT +24V Supply Failure RAP
03-480 The IOT has detected a +24V supply fault.
Initial Actions
Measure the voltage from F1 fuse on the IOT PWB to the machine frame. The F1 is a small
white fuse under PJ27 on the IOT PWB. Refer to 01G +24V Distribution RAP, Figure 4. If the
voltage is less than +24V, install a new LVPS, PL 1.10 Item 3.
Procedure
1. Perform the OF7 IOT PWB Diagnostics RAP.
August 2007
2-102 WorkCentre 5687 Family