Rep 12.23-171 Bm Entry Sensor - Xerox ColorQube 9303 Series Service Manual

5. Figure 1, remove the BM Entry Roll.
Figure 1 Roll removal
Replacement
Reverse the removal procedure to replace the BM entry roll.
NOTE: Tension the drive belt by loosening then tightening the screw,
Repairs/Adjustments
REP 12.22-171, REP 12.23-171
1
Remove E-clip, bearing,
pulley and belt.
2
Remove E-clip and
bearing.
3
Remove the
entry roll.
ADJ 12.10-171

REP 12.23-171 BM Entry Sensor

Parts List on PL 12.150.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the HVF BM front door and fully pull out the BM module.
2. Remove the crease blade knob (6d),
3. Remove the crease roll handle (6c),
4. Remove the BM front cover,
5. Figure 1, remove the BM entry sensor.
February 2013
4-152
WARNING
WARNING
GP 14. Disconnect the power cord from the cus-
PL 12.150 Item 4.
PL 12.150 Item 5.
PL 12.150 Item 3.
ColorQube® 9303 Family