012-903 Paper Remains At Compiler Exit Sensor Rap - Xerox WorkCentre 5222 Service Manual

012-903 Paper Remains at Compiler Exit Sensor RAP

BSD-ON:12.16
Paper remains on the Compiler Exit Sensor.
Initial Actions
Remove foreign substances on the sensor.
Power OFF/ON
Procedure
Execute Component Control[012-150 Compile Exit Sensor]. Actuate the Compiler Exit Sensor
with paper. The display changes.
Y N
Check the connections of J8868 and P/J8988.
correctly.
Y N
Connect J8868 and P/J8988.
Check the wire between J8868 and J8988 for an open circuit or a short circuit (BSD
12.16). The wire between J8868 and J8888 is conducting without an open circuit or
a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Finisher PWB P8988-3 (+) and GND (-) (BSD 12.16).
The voltage is approx. +5VDC.
Y N
Replace the Finisher PWB (PL
Measure the voltage between the Finisher PWB P8988-2 (+) and GND (-) (BSD 12.16).
Actuate the Compiler Exit Sensor with paper. The voltage changes.
Y N
Replace the Compiler Exit Sensor
Replace the Finisher PWB (PL 23.16).
Replace the Finisher PWB (PL 23.16).
Launch Version
WorkCentre 5225, 5230
J8868 and P/J8988 are connected
23.16).
(PL 23.14).
February, 2008
2-149
Status Indicator Raps
012-903