Standard Toolkit; Contents, Standard Toolkit - ABB IRB 14000 Product Manual

7.7 Standard toolkit

General
All service (repairs, maintenance, and installation) procedures contains lists of
tools required to perform the specified activity.
All special tools required are listed directly in the procedures while all the tools
that are considered standard are gathered in the standard toolkit and defined in
the following table.
This way, the tools required are the sum of the standard toolkit and any tools listed
in the instruction.

Contents, standard toolkit

Qty
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
i
Product manual - IRB 14000
3HAC052983-001 Revision: D
Tool
Torque screwdriver JOFAST 70-ICP range 0.07-0.70 Nm
Torque screwdriver JOFAST 170-ICP range 0.17-1.70 Nm i
Torque screwdriver JOFAST 450-ICP range 0.45-4.50 Nm i
Torque screwdriver TLS1360 range 2.5-13.6 Nm i
Screw bit (3mm--1/4'' )
Screw bit (3mm--1/4''(BALL HEAD))
Screw bit (2mm--1/4'' )
Screw bit (2mm--1/4''(BALL HEAD) )
Screw bit (TX6--1/4'' )
Screw bit (1.5mm--1/4'' )
Screw bit (1.5mm--1/4''(BALL HEAD) )
Screw bit (1.0mm--1/4'' )
Screw bit (TX10--1/4'' )
Screw bit (TX20--1/4'')
Screw bit (4mm--1/4'' )
Screw bit (4mm--1/4''(BALL HEAD) )
Wrench 7mm
Wrench 8mm
The standard torque screwdriver should be calibrated to the torque value specified in the repair
procedures, in advance.
© Copyright 2015 - 2016 ABB. All rights reserved.
7 Reference information
7.7 Standard toolkit
Note
i
449