ABB IRB 14000 Product Manual page 76

Hide thumbs Also See for IRB 14000:
Table of Contents

Advertisement

2 Installation and commissioning
2.3.3 Orienting and securing the robot
Continued
Level surface requirements
Orienting and securing the robot
Use this procedure to orient and secure the robot to a table.
1
2
3
4
5
6
7
8
9
76
Action
Make sure the installation site for the robot con-
forms to the specifications in section:
Pre-installation procedure on page 60
Prepare the installation site with attachment
holes.
CAUTION
The robot weighs 38 kg. All lifting equipment
must be sized accordingly!
CAUTION
When the robot is put down after being lifted or
transported, there is a risk of tipping, if not
properly secured.
Lift the robot to its installation site.
CAUTION
Be careful not to hit the arms into something
while lifting and transporting the robot. This could
damage the mechanical structure of the arm.
Make sure there are two pins in the holes in the
base.
Guide the robot using the pins, while lowering it
to mounting position.
Fit the securing screws in the attachment holes
of the base.
Tighten the bolts crosswise to ensure that the
base is not distorted.
© Copyright 2015 - 2016 ABB. All rights reserved.
xx1500000627
Information
The hole configuration of the base
is shown in the figure in:
Hole configuration, base on
page 74
How to lift the robot is described in
section:
Lifting the robot by two per-
sons on page 72
Lifting the robot with lifting
accessories on page 69
2 pcs, article number 3HNP00449-1
Make sure the robot base is cor-
rectly fitted onto the pins.
Screws: M5x25, (8 pcs ), quality:8.8.
Washers: 8 pcs, 5.3x10x1.
Tightening torque: 3.8 Nm ± 0.38 Nm
Product manual - IRB 14000
3HAC052983-001 Revision: D
0.1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents